A company has just negotiated a contract to produce a part for another firm.

Topic: PR – GradSchoolPapers.com
July 16, 2021
Economic feasibility analysis: Perform an economic cost- benefit analysis of whether PFVC should launch Chicken Sensations.
July 16, 2021

A company has just negotiated a contract to produce a part for another firm.

A company has just negotiated a contract to produce a part for another firm. In the process of manufacturing the part, the inside diameter of successive parts becomes smaller and smaller as the cutting tool wears. However, the specs are so wide relative to machine capabilities that it is possible to set the diameter initially at a large value and let the process run for a while before replacing the cutting tool.
       The inside diameter decreases at an average rate of .001 cm per part, and the process has a standard deviation of .05 cm. The variability is approximately normal. Assuming a three-sigma buffer at each end, how frequently must the tool be replaced if the process specs are 3 cm and 3.5 cm. Use (Number of shafts)n = 1.

Picture

Determine how many pieces can be produced before the LCL just crosses the lower tolerance of  3 cm. (Do not round your intermediate calculations.)

 

  After [removed] pieces the cutting tool should be replaced.
 
Do you need a similar assignment done for you from scratch? We have qualified writers to help you. We assure you an A+ quality paper that is free from plagiarism. Order now for an Amazing Discount!
Use Discount Code "Newclient" for a 15% Discount!

NB: We do not resell papers. Upon ordering, we do an original paper exclusively for you.

Buy Custom Nursing Papers